Deathloop: How to hack sensors - Tips and tricks - Ultimate Guide

Deathloop keeps giving us more activities and that's why we tell you how to hack sensors.

What's the point of hacking sensors in Deathlopp?

Simply having the ability to turn them off to prevent alarms that may sound as we move around these sides, this because when they sound they can make our enemies be alert to our location.

How to hack sensors in Deathloop?

Read Also:

• Deathloop: How to open secret bunker Z-29 behind the locked door in Fristad Rock
• Deathloop: How to Kill Charlie

It is necessary to understand that the sensors are usually similar to a camera that tends to emit a blue light and take charge of constantly scanning the area, in this sense, it is usually essential to avoid stepping on the light so that it does not sound the alarm In this sense, we must locate ourselves near the sensor range with our hackamajing and proceed to press and hold the button to activate the device, it is possible to take care of pressing the L1 button, turn off and turn on the hack when it is complete.

As the light is blue, it tends to turn green, once this has occurred, we are allowed to pass through the sensor without being detected, so it is essential to have hackamajing to take over the device, in case of not being able to seize us we will get several enemies that can locate us and therefore attack us, in fact the hacking effect continues to work even when we leave the area which is fantastic, because we do not necessarily have to be constantly hacking the same sensors.

 In this sense, knowing how to hack sensors allows us to have the possibility of mobilizing without the enemies being able to notice it in Deathloop.